Vatrer 48V 600Ah Lithium Battery for Electric Forklifts Built for Long Shifts

Our 48V 600Ah lithium battery provides 30.72kWh of energy, but forklift runtime is not a fixed number of hours. Load weight, lift frequency, travel distance, and daily duty cycle all change energy use. If you already track your forklift’s average power consumption, dividing 30.72kWh by that average load gives you a practical starting point for estimating operating time between charges.

Yes. The 48V forklift battery provides 30.72kWh of energy for extended material-handling work, making it well suited to forklifts that stay active through long warehouse, logistics, or manufacturing shifts. The real-time SOC display also lets operators track remaining charge during the day and schedule charging before the battery reaches a low state, helping reduce unplanned downtime between shifts.

Yes, this battery is designed for converting suitable 48V electric forklift applications from lead-acid to lithium power. Our setup uses a REMA DIN320A charging interface and an Anderson SB350 discharge connector, while the lighter lithium battery can be installed with the counterweight needed to maintain the forklift’s required operating weight. 

Yes. We supply the electric forklift battery with its matched charger, along with the monitoring display, connection cable, and installation hardware. Using the supplied charging system also avoids trying to run the lithium battery from a charger intended for a traditional lead-acid battery.

The battery can supply up to 700A peak current for 30 seconds, giving the forklift additional current during high-demand moments such as loaded acceleration and lifting. This is especially relevant in warehouse and manufacturing work where the truck repeatedly moves and raises heavy pallets rather than operating at a steady light load.

Our monitoring display shows SOC, voltage, current, and battery status in real time. Operators can check the remaining charge directly during the shift and plan charging around the work schedule instead of waiting for noticeable changes in forklift performance.

The 350A BMS automatically manages overcharge, over-discharge, overcurrent, short circuit, and high- or low-temperature protection. If an electrical or temperature condition moves outside the battery’s protected operating range, the BMS responds automatically to help prevent continued operation from stressing the battery.

Vatrer uses a three-level alarm system for voltage, temperature, and fault conditions. Intermittent, rapid, and continuous alarm patterns make different levels of abnormal operation easier to recognize, so the operator has a visible and audible indication that the battery needs attention rather than discovering the issue only after the forklift stops.

No watering is required. Unlike a flooded lead-acid forklift battery, this lithium design eliminates electrolyte water checks and the routine topping-off associated with lead-acid maintenance. Keeping the connectors and battery area clean and inspecting the installation during normal forklift service are the main practical upkeep tasks.

The BMS includes both high- and low-temperature protection, so the battery can respond automatically when temperature moves outside its protected operating range. In facilities exposed to extreme heat or cold, keeping charging areas within a more moderate temperature range helps prevent temperature protection from interrupting charging or operation and keeps the forklift available for the next shift.